Nerf Hut
Powerclip Mods

HOME

Reviews
Modifications
Research and Development
Homemade's

Four PC mod's to make it shoot faster, shoot farther/fire stefans, make the clip removable, and DarkHelmet's own, make the clip easily removable once you've fired all ten darts.

In order to make your gun shoot faster, you must first open up your gun. Once inside, you'll see it's a pretty simple gun. Locate the rubber black air tank, or called the bladder. Wrap two rubber bands around the bladder, wrap them around it two or three times. Make sure you don't put too many on, or wrap them around too tight. If the bladder is too restricted, then it won't shoot as far or as fast as it does without the bands on it.

bladder.jpg

In order to make your PC shoot a little farther and fire stefans, your going to need to open up your gun. It's easiest, however, to just take the three screws out that are near the clip of the gun first, and then pry out the clip. Don't worry, it won't break.
      Now that you have the clip out, take a look at the back of it. You should notice small addition signs ( + ) in each of the ten holes. Take a sharp excato knife or needle nose plyers and just snap those off. You don't need the peg that they are attached to, either.
    And your done! Your gun will now be able to fire stefans (homemade darts) and will fire a little bit farther. Now that you have the clip out, why not look down and do the removable clip mod?

xpics.jpg

If you have your clip out of your gun, good. If you don't, do the above mod first. Now, look at the bottom of the clip. There are ridges on both sides of the clip. hacksaw those of, it doesn't have to be excatly level to the rest of the clip, as long as they are off and no bit is protruding. Now you can remove your clips and use them interchanably from guns. It's best to get atleast two, preferably three clips for a fast reload. Otherwise the PC is a terrible automatic.

bottom.jpg

By Dark Helmet:
In order to  make the clip easy to remove once all ten darts have been fired, you need to closely look at your clips. On one side of the clip there are ten plastic shapes that look like a trapezoid, although they only have one angle which is on the right hand side. That angle is the only important thing about them. When your PC fires, it uses a part (it's green) in your gun to advance to the next bullet. The part is angled at a similiar degree to the one on your clip, thus it will push it up. Now, in order to make your clip easier to remove from the gun once you have fired, you need to make two extra plastic pieces on your PC. I recommend practicing first on some paper to make sure you have the right shape, but once you have it down, make it out of hot glue on your clip a little under a centimeter below the last plastic piece. Make a second under that. Now, when your PC gets to the last plastic piece, it will still try to advance, but because you have your hot glue piece on it, it should advance twice if done right. Now all you need to do to remove the clip from your gun is turn it sideways so it falls (on a soft surface, I hope). You may need to do a routine maintence on the new pieces, because eventually the hotglue will wear down. This should make it easier, and faster to change clips.

ricoclipmod.jpg